Hitachi VT-FX623A - Manual (Page 50)

50
to record with the VCR Plus+ system you need to assign your local broadcast and cable
channel numbers to the VCR Plus+ channel codes already stored in your VCR's
memory. This is called channel setup and you do it using the on-screen Easy Guide
System and the following step-by-step instructions. Then you will be ready to begin
VCR Plus+ recording, also using the on-screen Easy Guide System.
VCR Plus+ and PlusCode are trademarks of Gemstar Development corp.
Channel setup
Before you begin
1 Look for a listing like this one in your local TV program guide or Sunday newspaper
TV section. Notice the small numbers to the right of the station name.
These are the VCR Plus+ channel numbers that you will use in the channel setup
procedure.
2 Make a list of the VCR Plus+ channel numbers and the channel numbers you are
receiving them on. If there are any difference, YOUR channel numbers must be
assigned to the corresponding VCR Plus+ number. (See Example)
Note in the example that the channel numbers are the same except for 20 (received on
channel 8) and 42 (received on channel 38). These two channels must be assigned.
EASY DELAYED RECORDING WITH THE VCR PLUS+ SYSTEM
This setup should be performed if you are using an Antenna or Cable without a cable
box. (Hookups [A], [B], [C] or [D].) If you receive all your channels through a cable box
(Hookups [E], [F] or [G]) please refer to page 26 "cable box setup" in "First Time Setup"
section.