Hitachi VT-FX623A - Manual (Page 38)

38
Press the DISPLAY button a third time to see the tape remaining time.
Note: Immediately after the tape is inserted, "-:--" will appear.
2 minutes after playback or recording is started, the tape remaining time is displayed.
Press the CLEAR button repeatedly to switch the type of the tape used. The correct
remaining time will appear.
AUTO: T-120 or shorter tape
T-160: T-140 or T-160 tape
T-180: T-180 tape
T-210: T-210 tape
Notes:
• The tape remaining time is not displayed correctly for a tape without any recordings or tapes
other than T-30/60/90/120/140/160/180/210.
• The remaining time may not be displayed correctly during fast forwarding or rewinding.
INDEX WITH THE TIME COUNTER
To find specific sections on a tape
Indexing with the Time Counter
You can set the time counter to memorize a certain point in the video programming, and
you can return to that point automatically.
Remote Control Illustration
1 Press the DISPLAY button two or three times.
The counter will appear in the VCR's display.
2 Begin recording or playing back a tape.
3 At the point that you want to go back to, press the CLEAR button.
This resets the counter to 0:00:00.
4 Press the STOP button when you are done recording or playing back the tape.