HANNspree 1506-060B000 - Manual (Page 31)

30
Engli
sh
3.4 Adjusting Channel Settings
1 Press MENU to enter the OSD Main Menu
screen.
2 Press / on the remote control or
CHS / CHT on the control panel to select
Channel menu.
3 Press / OK on the remote control or
INPUT/ VOL+ on the control panel to enter
the Channel menu.
4 Press / on the remote control or CHS / CHT on the control panel to select an
item.
5 Press / OK on the remote control or INPUT/ VOL+ on the control panel to enter
the item.
6 Press / on the remote control or VOL+ / VOL- on the control panel to change
the scales or press OK on the remote control or INPUT/ VOL+ on the control panel to
mark an item.
7 Press RETURN to return to the Channel menu.
8 Press MENU/ VOL- to exit the Channel menu.
9 The Channel menu can be used to perform a channel search and edit channel list
(see “Performing an Automatic Channel Search” on page 25 and “Editing Channel
Table or Favorite Channel” on page 26).
•The Antenna can be set to
Air or Cable.
•The Scan Mode can be set to Auto , Analog, or Digital.
•The Auto Scan can be set to Auto , Standard, HRC, or IRC.
Note:
The Channel settings are available when the signal is set to TV source.
Picture
Audio
Channel
V-CHIP
Setup
Antenna
Scan Mode
Auto Scan
Channel List
Exit Return Enter Menu Move Return OK