HANNspree 1506-060B000 - Manual (Page 30)

29
English
3.3 Adjusting Audio Settings
1 Press MENU to enter the OSD Main
Menu screen.
2 Press / on the remote control or
CHS / CHT on the control panel to select
Audio menu.
3 Press / OK on the remote control or
INPUT/ VOL+ on the control panel to
enter the Audio menu.
4 Press / on the remote control or CHS / CHT on the control panel to select
an item.
5 Press / OK on the remote control or INPUT/ VOL+ on the control panel to enter
the item.
6 Press / on the remote control or VOL+ / VOL- on the control panel to change
the scales or press OK on the remote control or INPUT/ VOL+ on the control panel
to mark an item.
7 Press RETURN to return to the Audio menu.
8 Press MENU/ VOL- to exit the Audio menu.
9 The Audio menu can be used to adjust the Audio Mode, Equalizer, Balance, MTS
(ATV only), Auto Volume (ATV only), and Recall settings. Equalizer is available
for adjustment only if you select User in Audio Mode.
•The Audio Mode can be set to Dynamic,
Standard , Soft, or User.
•Press / on the remote control or VOL+ / VOL- on the control panel to adjust
the scales in Equalizer and Balance.
•The MTS can be set to Stereo , Mono, or SAP.
•The Auto Volume can be set to Off or On.
•The Recall can be used to reset the original factory settings.
Note:
The items available on the OSD may vary depending on the input signal source.
Picture
Audio
Channel
V-CHIP
Setup
Audio Mode
Equalizer
Balance
MTS
Auto Volume
Recall
Exit Return Enter Menu Move Return OK