Heat & Glo Fireplace 2197-980 - Manual (Page 48)

Heat & Glo • SOHO-N-AUB • 2197-980 Rev. G • 2/13 48
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
Introduction
The RC300AU multifunctional remote control is de-
signed to control pilot light, flame height, blower speed,
and up to two 220-240 VAC auxiliary functions on your
gas fireplace. The RC300AU is equipped with thermo-
stat functions which can automatically control the tem-
perature in the room in which it is installed. The control
is only for use with the Hearth & Home Technologies
IntelliFire Plus™ system (IPI). The AUX300CE module
is rated for 220-240 VAC, 50-60 Hz, and is required for
operation of this remote control device.
Installation Precautions
The installation of this remote control must be performed
by a qualified service technician. This remote control is
tested and safe when installed in accordance with this
installation manual. Do not install any components that
may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must
be done by a qualified service technician.
Placement of this remote control may affect performance.
An assessment of the space should be done prior to in-
stallation for optimum performance.
Determine Location
Determine the location for the remote control. The selected
location should be in the same space as the gas fireplace.
Never place this unit in a separate room. The remote control
must be placed within 30 ft. (9.14 m) of the fireplace but
should not be exposed to extreme heat.
The RC300AU is approved for interior installation and
should not be used in exterior applications.
• Keep remote control out of reach of children.
Fireplace Specific Information
Standard fireplace features vary. Consult the installation
manual for available options.
The optional
AUX300CE receiver provides additional fea-
tures: Fan control and two Aux functions.
The
REM300-HNG-AU remote control system functions
include: On/Off, Thermostat Mode, Timer Countdown,
and Flame Adjustment (for fireplaces with variable flame).
Kit Contents
REM300-HNG-AU
• RC300-HNG-AU Transmitter
• AAA Batteries (3)
• Wall Holder
• Drywall Anchor (2)
• Screws (2)
D. Control Module Operation
See Section 2.I for Control Module Operation.