HP Home Theater System - Manual (Page 90)

84 HP Digital Entertainment Center
One Cable TV Box or Digital Cable Receiver
(NTSC) and Antenna (ATSC)
To connect a standard set-top box (sold separately) and
an HDTV/SDTV Ant. In input to your HP Digital
Entertainment Center using a standard set-top box,
satellite receiver, or digital cable receiver with S-video or
composite video output, do the following:
1 Make sure that a coaxial cable connector from your
cable TV source (wall) is plugged into the set-top box
or digital cable receiver In connector.
2 Connect a video cable:
a Choose a video out connector:
■ Coaxial (RF)
■ Video (composite)
■ S-video
b Connect the video cable from the set-top
box or digital cable receiver back panel Video
Output connector.
c Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
3 Connect stereo audio cables (skip this step if using
coaxial [RF]):
a From the set-top box or digital cable receiver
back panel Audio Out right (red) and Audio Out
left (white) connectors.
b Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
4 Connect the coaxial cable from the UHF/VHF
antenna into the HDTV/SDTV Ant. In HDTV/SDTV
Ant. In connector on the back of the HP Digital
Entertainment Center.
5 Connect the set-top box Infrared Transmitter cable
(required for signal). See “Infrared Transmitter
Connection” on page 97.