Hoshizaki KM-61BAH - Manual (Page 58)

53
7) Lift up the front of the body, and place a block between the body and base to allow
space for servicing.
8) Disconnect the copper tubes at the inlet and outlet.
9) Remove the screws and take off the Condenser.
10) Install the new Condenser.
11) Remove the Drier using brazing equipment.
12) Install the new Drier (see “4. DRIER”).
13) Braze all fi ttings with nitrogen gas fl owing at a pressure of 3 - 4 PSIG.
14) Check for leaks using nitrogen gas (140 PSIG) and soap bubbles.
15) Evacuate the system, and charge it with refrigerant (see “1. [c] EVACUATION AND
RECHARGE”).
16) Reconnect the fl are connections.
17) Replace the Inlet Nut for the Water Valve.
18) Open the water supply line Shut-off Valve.
19) Check for water leaks.
20) Secure the body with the four bolts.
21) Replace the panels in their correct positions.
22) Plug in the icemaker or connect the power source.