HP WS460C G6 User Manual
Page 34
Performing an unattended installation of Windows XP 34
hpcisss2.sys
hpcissx2.inf
—
Add to the [GuiUnattended] section:
[GuiUnattended]
AutoLogonCount=2
—
Add to the [NetOptionalComponents] section:
[NetOptionalComponents]
SNMP = 1
This entry installs SNMP during setup. This entry must be made must be made, or the
management agents will not install correctly.
—
Add to the [GuiRunOnce] section:
[GuiRunOnce]
"%systemdrive%\HP_Install\Driver_Software_Install2.cmd"
This entry runs the install script Driver_Software_Install.cmd, which will install drivers and
software at first login after install.
—
Add to the [WindowsFirewall] section:
[WindowsFirewall]
Profiles = WindowsFirewall.TurnOffFirewall
[WindowsFirewall.TurnOffFirewall]
Mode = 0
In this example, the Windows® firewall is disabled (see Windows® documentation on firewall
settings). In practice, HP does not recommend disabling the Windows® firewall unless another
firewall is in use. See "Configuring the operating system (on page
)" for recommended
firewall settings.
—
(Optional) [NetAdapters] sections—To ensure that the network card is enumerated correctly,
specifically state them in the unattended file. For example:
[NetAdapters]
Adapter01=Params.Adapter01
Adapter02=Params.Adapter02
[Params.Adapter01]
InfID="b06bdrv\l2nd&pci_164c14e4"
PciBusNumber = 3
PciDeviceNumber = 0
PciFunctionNumber = 0
ConnectionName = "HP NC373i Multifunction Gigabit Server Adapter #1"
[Params.Adapter02]
InfID="b06bdrv\l2nd&pci_164c14e4"
PciBusNumber = 7
PciDeviceNumber = 0
PciFunctionNumber = 0
ConnectionName = "HP NC373i Multifunction Gigabit Server Adapter #2"
6.
Using an RIS server—If you are using Microsoft® RIS, you must add network drivers to the i386
(Windows® XP Professional SP3) or AMD64 (Windows® XP Professional x64 Edition SP3)