HP WS460C G6 User Manual
Page 33
Performing an unattended installation of Windows XP 33
The above entry installs SNMP during setup. This is required in order for the management
agents to install.
—
Add to the [GuiRunOnce] section
[GuiRunOnce]
"%systemdrive%\HP_Install\Driver_Software_Install2.cmd"
The previous entry will run the Driver_Software_Install.cmd install script that will install
drivers and software at first login after install.
—
Add to the [WindowsFirewall] section
[WindowsFirewall]
Profiles = WindowsFirewall.TurnOffFirewall
[WindowsFirewall.TurnOffFirewall]
Mode = 0
In the previous firewall example, the Windows® firewall is disabled see the Windows®
documentation on firewall settings). In practice, HP does not recommend disabling the
Windows® firewall unless another firewall is in use. For more information, see "Configuring the
operating system (on page
)".
b.
Windows® XP Professional x64 Edition
—
Add to the [Unattended] section:
Plug and Play driver location:
OemPNPDriversPath="\\%SERVERNAME%\RemInst\%INSTALLPATH%\$OEM$\textm
ode;Drivers\HP_NULL_IPMI;Drivers\HP_SmartArray_P410i_SAS;Drivers\In
tel_chipset;Drivers\ "
For both Windows® XP 32-bit Edition and Windows® XP Professional x64 Edition, the path for
the NVIDIA driver is intentionally omitted. Because the workstation blade contains two video
controllers, the workstation makes the NVIDIA driver primary during the install, and if Remote
Console Mode is in Setup Mode, the screens go black. This change occurs because the iLO
Remote Console and Local I/O Connector displays are controlled by the ATI controller, and are
deactivated if NVIDIA is the primary controller. The NVIDIA driver is installed later in the
installation process and activated before switching to User Mode.
The ATI drivers that are downloadable from the workstation blade software and drivers web
page are not Microsoft® signed. If you do not to use the unsigned drivers, the default VGA
driver in the operating system is loaded. Remove the ATI lines in the driver path to prevent the
ATI driver from loading.
Other settings:
OemPreinstall=Yes
DisableVirtualOemDevices=Yes
DriverSigningPolicy=Yes
—
Add to the [MassStorageDrivers] section:
[MassStorageDrivers]
"Windows Driver for Smart Array SAS/SATA Controllers"="OEM"
—
Add to the [OEMBootFiles] sections:
[OEMBootFiles]
txtsetup.oem
hpcisss2.cat