Heath Zenith MSL360FWPB - Manual (Page 2)

2 598-1351-01
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground.
NOTE: If fixture is mounted
higher than 8 ft. (2.4 m), aiming the sensors down will
reduce coverage distance.
For eave mount only:
❒
Swing the sensor heads toward the clamp screw
joint.
If a sensor pops out of the ball joint, loosen the clamp
screw and push the sensor back into the ball joint.
Tighten the clamp screw when done.
❒ Then rotate the sensor heads clockwise 180° so
the controls face down.
Controls
For under eave installation, the sensor heads must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
For second story installation, point one sensor head for-
ward for maximum coverage and point the other sensor
head downward for coverage close to the building.
Also, one sensor may be pointed toward a specific
area for coverage while the other is pointed forward for
maximum coverage.
Controls
Controls
Clamp Screw
Move ON-TIME Switch
to 1, 5, or 10 minutes
Mode Switching Summary
Flip light switch
off for one second
then back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
Wall Mount Eave Mount
Controls