Hoshizaki F043-809 KMD-410MWH - Manual (Page 53)

49
8) Connect the bin control connector to the side of the control box.
9) Replace the water tank, cube guide, pump motor bracket, pump motor and float switch in
their correct positions until they snap in place.
CAUTION
Be sure to let the discharge hose pass behind the copper tube and connect it
securely in position. Otherwise, the discharge hose may be caught in the front
insulation, leading to improper results.
10) Secure the pump motor bracket with the two thumbscrews.
11) Reconnect the pump motor connector and float switch connector.
12) Replace the front insulation and front panel in their correct positions.
13) Turn on the power supply.
17. THERMISTOR
1) Turn off the power supply.
2) Remove the panels.
3) Disconnect the connector of the thermistor lead (orange).