HP R507 - Manual (Page 112)

112 HP Photosmart R507/R607 User’s Manual
Resetting the Camera
If your camera does not respond when you press any buttons,
try resetting the camera as follows:
1 Holding the camera upside down with the front of the
camera facing you, open the Battery/Memory card door on
the bottom of the camera.
2 If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset, it eliminates the memory
card as a possible cause of the problem.)
3 Remove the battery from the camera, and make sure the
HP AC power adapter is not connected to the camera.
4 The Reset switch is the
small hole located above
the battery slot, as shown.
Press the straightened end
of a paper clip into the
Reset switch until the switch
is depressed, and hold it
down for approximately
five seconds, then remove
the paper clip. The camera is now reset.
5 Reinsert the battery and the optional memory card (if you
have one) and close the Battery/Memory card door. You
may now use the camera again.