Hitachi CP-X10000 - Manual (Page 52)

52
OPTION menu
Item Description
SERVICE
(continued)
REMOTE ID
Use the ▲/▼ buttons on the REMOTE ID menu to select ID and
press the ► button.
ALL у 1 у 2 у 3 у 4
The projector is controlled by the remote control whose ID button is
set the same number as this number. When the ALL is selected, the
projector is controlled by a remote control irrespective of the ID setting.
COMMUNICATION
Selecting this item displays COMMUNICATION menu.
In this menu, you can configure the communication settings
of the CONTROL IN and the CONTROL OUT ports.
• Select an item using the cursor buttons ▲/▼. Then
pressing the ► button opens the submenu for the
setting item you selected.Or, pressing the ◄ button
instead of the ► button makes the menu back to the
previous one without changing the setup.
Each submenu can be operated as described above.
COMMUNICATION TYPE
In this menu, you can select
the communication type for
transmission from the CONTROL
OUT port.
NETWORK BRIDGE ó DAISY CHAIN ó OFF
NETWORK BRIDGE: Select this type, if it is required
to control an external devise as a network terminal, via
this projector from the computer. (Network Guide -
3.7 Controlling the external equipment via the projector
(using the NETWORK BRIDGE function))
• The selectable items on the
COMMUNICATION menu are varied according to
the setup of the COMMUNICATION TYPE.
• For the function of serial communication, refer to
the Network Guide (Network Guide - 3.7, 3.8).
NOTE
COMMUNICATION TYPE ó SERIAL IN SETTING
 
COMMUNICATION ID SERIAL OUT SETTING
 
COMMUNICATION GROUP TRANSMISSION METHOD
 
BYTES INTERVAL TIMEOUT ó RESPONSE LIMIT TIME