Hitachi CP-X10000 - Manual (Page 21)

21
Operating
Using the functions for the lens
ZOOM / FOCUS
Press the ZOOM / FOCUS button. The ZOOM / FOCUS dialog
will appear. Adjust the zoom / focus using the ◄/► button while
the dialog is displayed. Press the ▼ button to select "EXIT" on
the dialog. It finishes the OSD menu.
LENS SHIFT
Press the LENS SHIFT button. The LENS SHIFT dialog
will appear. Using the ▲/▼/◄/► buttons while the dialog
is displayed shifts the lens.
 In the LENS SHIFT dialog:
Press the DIGITAL button.
 In the standby mode:
Press the LENS SHIFT and the DIGITAL buttons for 3 seconds at the same time.
CENTERING
● While the lens is shifting, the menu will disappears and the icon of hourglass will
appears on screen. Shifting may take some time. Depending on the case, it may
reach one minute.
● The LENS SHIFT indicator lights up or blinks in green while the lens is shifting.
Then the indicator will stop blinking and light for 3 seconds in steady green
when the centering is complete.
● When the lens is located in the center already, pressing the DIGITAL button in the
LENS SHIFT dialog lights in steady green the LENS SHIFT indicator for 3 seconds.
LENS MEMORY
SAVE / LOAD / CLEAR
This projector is equipped with memory functions for the lens adjustments (zoom,
focus and shift).
To display the LENS MEMORY dialog, select the LENS MEMORY on the ZOOM,
FOCUS or LENS SHIFT dialog. Then the LENS MEMORY dialog will appear.

SAVE:To save the current lens adjustments, select
a SAVE-(1-3) and press ► or ENTER button.
 LOAD:To load a saved adjustments, select the
LOAD-(1-3) and press ► or ENTER button.
When the MY BUTTON button is allocated to
the LOAD-(1-3) the memory can be loaded
without the LENS MEMORY dialog.
 CLEAR:Selecting the CLEAR LENS MEMORY in the LENS MEMORY dialog
displays CLEAR LENS MEMORY dialog. Select the number to be cleared
using ▲/▼ buttons and press the ► button. The dialog to check your intention
will come out. Then press the ► button again in the dialog.
• The adjustable range of ZOOM and FOCUS
varies depending on the lens unit mounted on the
projector to maintain picture quality. Therefore ZOOM or
FOCUS adjustments may not reach the end of the bar
indicators in the dialog, and that is not a failure.
NOTE