Setup menu – Hitachi CP-X10000 User Manual

Page 40

SETUP menu

From the SETUP menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor
button on the projector or remote control, or the
ENTER button on the remote control to execute the
item. Then perform it according to the following table.

Item

Description

AUTO

KEYSTONE

Selecting this item performs the Automatic keystone distortion

correction. Projector automatically corrects vertical keystone

distortion due to the (forward/backward) setup angle by itself.
This function will be executed only once when selected in the menu.

When the slant of the projector is changed, execute this function

again.
• The adjustable range of this function will vary among inputs. For

some input, this function may not work well.

• When V:INVERT or H&V:INVERT is selected to the MIRROR item

in the SETUP menu, if the projector screen is inclined or angled

downward, this function may not work correctly.

• When the zoom adjustment is set to the TELE (telephoto focus),

this function may be excessive. This function should be used when

the zoom adjustment is set to the full WIDE (wide-angle focus)

whenever possible.

• When the projector is placed on the level (about ±3°), this function

may not work.

• When the vertical lens shift is not set fully upward (not set fully

downward for the optional lens type USL-801 only (

51), this

function may not work well.

• When the horizontal lens shift is not set to the center, this function

may not work well.

• This function will be unavailable when the Transition Detector is

on (

64).

KEYSTONE

Using the ◄/► buttons corrects the vertical keystone distortion.

Shrink the bottom of the image ó Shrink the top of the image

• The adjustable range of this function will vary among inputs. For