Hitachi CP-X10000 - Manual (Page 19)

19
Operating
1. Make sure that the power cord is firmly and
correctly connected to the projector and the outlet.
2. Press down the side marked “I” on the power
switch.
The POWER indicator will light up in steady
orange.
Then wait for the buttons to become ready. It may
take several seconds.
3. Press the STANDBY/ON button (on the projector
or the remote control).
The projection lamp will light up and the POWER
indicator will begin blinking in green. When the
power is completely on, the indicator will stop
blinking and light in steady green.
To display the picture, select an input signal according to the section "Displaying
and switching the image" (
22).
Turning on
The following walks you through the steps to turn the projector on. For other
devices, follow the manual of each.
• When the item DIRECT ON of the OPTION menu is set to the ON,
and that the projector was turned off by only the power switch without using
the STANDBY/ON button, switching the power switch on turns the projector on
without the formal procedure shown above.
NOTE
►Do not look directly into the lens or the openings on the
projector while the lamp is on.
►Do not approach the lamp cover and the exhaust vents, while the projection
lamp is on.
WARNING
►Do not turn your device on prior to the projector, except for the
cases directed by the manuals of devices.
NOTICE
STANDBY/ON
Power
switch
POWER indicator
STANDBY/ON
button
Operating