Hearth and Home Technologies Direct Vent Gas Appliance CNXT4236IT - Manual (Page 39)

Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08 39
Figure 9.11 Place Outer Collar on Rear of Appliance
• Place outer collar on rear of appliance and replace four
screws to hold collar in place. See Figure 9.11. Make
sure insulation is attached to the collar base!
Figure 9.12 Cover Plate Placed on Rear of Appliance
• Locate the cover plate removed in the second step. Place
plate around rear vented collars and replace four screws
to hold plate in place. See Figure 9.12.
• Place inner cover plate on appliance top and replace
four screws to hold inner cover plate in place. See
Figure 9.14. Make sure gasket is replaced with the cover
plate!
Figure 9.14 Inner Cover-Top
Figure 9.15 Outer Cover-Top
• Place outer cover plate on appliance top and replace
four screws to hold outer cover plate in place. See
Figure 9.15. Make sure insulation is replaced with cover
plate!
• Place the white insulation with the slot around the outer
collar. See Figure 9.13.
Figure 9.13 Place Insulation over the Cover Plate