Hearth and Home Technologies Direct Vent Gas Appliance CNXT4236IT - Manual (Page 37)

Heatilator • Caliber CNXT Series • 4047-132 Rev U • 11/08 37
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during installa-
tion. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
A. Convert from Top Vent to Rear Vent
9 9
Appliance Preparation
Figure 9.1 Cover Plate, Top of Appliance
• Remove the screw holding heat shield cover plate to top
of appliance and set aside. See Figure 9.1
• Remove three remaining screws holding the plate
surrounding fl ue. See Figure 9.3. Remove plate and set
aside.
Figure 9.3 Cover Plate, Remove Screws
• Remove four screws holding inner plate surrounding the
fl ue. See Figure 9.4. Remove inner plate and discard.
Figure 9.4 Inner Plate, Top of Appliance
Note: If the appliance is to be top vented discard this
plate and replace the screw you removed. If the appliance
is to be rear vented, continue to the next step and
Figure 9.2.
• Remove the white insulation and set aside. See
Figure 9.2.
Figure 9.2 Remove White Insulation