Heat & Glo Fireplace VRT-BZ-P-AUB - Manual (Page 44)

Heat & Glo • VRT-AUB • 2123-980 Rev. J • 2/13 44
J. Inner Glass Door Assembly Replacement
Turn the gas stove OFF and let it cool down before replac-
ing the inner glass door assembly.
With the front door assembly removed from the gas stove,
remove the inner glass door assembly by disengaging the
spring-loaded latches at the bottom of the gas stove and
lifting off of the two spring-loaded latches at the top of the
gas stove.
Replace with a new inner glass door assembly.
I. Front Door Glass Assembly Installation
Remove the front door assembly by pulling bottom of
front away from gas stove and lifting it off of the hooks on
top of the gas stove (see Figure 9.16).
Refer to Figure 9.17: Position the four flat 6 mm spacer
washers on the front door so that the four mounting screws
pass through them. Position the glass over the front door.
Install the four protective barrels into the glass and the
four nylon washers on top of the glass.
From inside the door front, pass the screws through to the
outside and thread on the caps until tight.
Figure 9.18 Complete Assembly
Cap and Barrel Fastener System
Nylon washer on back
and front of glass Screw
Finishing Cap
Protective barrel sleeve
through hole in the glass
Back side of
front door
Figure 9.17
Figure 9.16
Handle glass doors with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate gas stove with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete gas stove.
WARNING