Heat & Glo Fireplace Heat-N-Glo 6000XLT-CDN - Manual (Page 38)

38
Positioning the Logs
If the gas logs have been factory installed they
should not need to be positioned.
If the logs have been packaged separately, refer to
the installation instructions that accompany the
logs. Save the log instructions with this
manual.
If sooting occurs, the logs might need to be
repositioned slightly to avoid excessive flame
impingement.
Placing the Ember Material
Two separate bags of ember material are shipped
with this gas fireplace:
• The bag labeled Golden Ember (GE-93) is flame
colorant material.
• The bag labeled Glowing Ember (050-721) is
standard glowing ember material.
To place the ember material:
• Turn the tension springs around the glass door 90°.
• Remove the glass door from the unit.
• NOTE: FOR MODEL 6000ARCH ONLY.
Remove wing nuts and glass clips. Pull glass out
from bottom and pull downward.
• Cover the top of the burner with a single layer of
ember material. Then sprinkle GE-93 on top of
the burner.
• Save the remaining ember materials for use
during fireplace servicing.
• Replace the glass door and a front trim door on
the unit (see Replacement Parts Section of the
manual.)
• Pull out and twist the tension springs 90° to lock.