beautypg.com

Advanced ecc memory – HP DL580 User Manual

Page 40

background image

Hardware options installation 40

FBDIMMs must be ECC Registered DDR-2 SDRAM FBDIMMs.

FBDIMMs must be installed in sequential order, beginning with bank A.

FBDIMMs must be installed in pairs.

FBDIMM pairs in a memory bank must have identical HP part numbers.

FBDIMMs must be populated as specified for each AMP memory mode.

The memory subsystem for this server is divided into two branches. Each memory branch is essentially a

separate memory controller. The FBDIMMs map to the two branches as indicated in the following table:

Branch 0

Branch 1

FBDIMM 1A

FBDIMM 9B

FBDIMM 5A

FBDIMM 13B

FBDIMM 2C

FBDIMM 10D

FBDIMM 6C

FBDIMM 14D

FBDIMM 3E

FBDIMM 11F

FBDIMM 7E

FBDIMM 15F

FBDIMM 4G

FBDIMM 12H

FBDIMM 8G

FBDIMM 16H

Memory board 1 (optional)

Memory board 3 (optional)

Memory board 2 (optional)

Memory board 4 (optional)

This multi branch architecture provides enhanced performance in Advanced ECC mode. The concept of

multiple branches is important for the operation of online spare mode and mirrored memory mode.
If the server contains more than 4 GB of memory, consult the operating system documentation about

accessing the full amount of installed memory.

Advanced ECC memory

Advanced ECC memory is the default memory protection mode for this server. In Advanced ECC, the

server is protected against correctable memory errors. The server provides notification if the level of
correctable errors exceeds a pre-defined threshold rate. The server does not fail because of correctable

memory errors. Advanced ECC provides additional protection over Standard ECC because it is possible

to correct certain memory errors that would otherwise be uncorrectable and result in a server failure.
Whereas standard ECC can correct single-bit memory errors, Advanced ECC can correct single-bit
memory errors and multi-bit memory errors if all failed bits are on the same DRAM device on the

FBDIMM.
Advanced ECC memory supports the following FBDIMM configurations:

Configuration Bank

A

1A/5A

Bank B
9B/13B

Bank C
2C/6C

Bank D
10D/14D

Bank E
3E/7E

Bank F
11F/15F

Bank G
4G/8G

Bank H
12H/16H

1 X

2 X

X

3 X

X

X

4

X X X X

This manual is related to the following products: