Hardware options installation, Introduction, Processor options – HP DL580 User Manual
Page 33: Removing the processor memory module
Hardware options installation 33
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Review "Electrostatic Discharge (on page
)" before installing hardware options into the server.
Processor options
The server supports up to four processors. Observe the following processor installation guidelines:
•
Processor socket 1 and PPM 1 must be populated at all times so that the server functions properly.
•
Each PPM provides power to each processor. Each PPM must be installed in the slot adjacent to its
processor.
•
Processors must be installed in the following order: processor 1, processor 2, processor 3, and
processor 4.
•
When upgrading processor speed, update the system ROM before installing the processor.
•
Multiprocessor configurations must contain processors with the same part number.
Removing the processor memory module
The processors and memory are stored in a module at the front of the server. Access to the processor
memory module is provided through the front panel, eliminating the need to extend the server from the
rack to install new or replace existing processors or upgrade the memory.
To remove the processor memory module:
WARNING:
Use caution when installing the processor memory module or removing the
processor memory module. The processor memory module is very heavy when fully populated.
1.
Power down the server (on page
).