HP J4367A - Manual (Page 36)

Installing the HP UPS Power Protection Agent 36
o Edit the
/etc/sysconfig/boot
file and change
RUN_PARALLEL="yes"
to
RUN_PARALLEL="no"
to remove parallel script execution.
-or-
o Edit the
/etc/init.d/.depend.start
file and add
DevMan: network
at the end of the
file to add parallel information for DevMan.
Installing the agent on an Itanium system
1. Install the
ia32*
file for your operating system from the supplementary disc.
2. Install the appropriate library files for your operating system from the compact layer in the following
order:
a. Install the
glibc*
library file.
b. Install the
zlib*
library file.
RH4-U3 RH4-U4 RH4-U5 RH5
ia32* ia32el-1.3-2.ia64.rpm ia32el-1.3-2.ia64.rpm ia32el-1.3-2.ia64.rpm ia32el-1.6-
13.el5.ia64.rpm
glibc* glibc-2.3.4-
2.19.i686.rpm
glibc-2.3.4-
2.25.i686.rpm
glibc-2.3.4-
2.36.i686.rpm
glibc-2.5-12.i686.rpm
zlib* zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.1.2-
1.2.i386.rpm
zlib-1.2.3-3.i386.rpm
3. Install the agent using the Linux installation script (" Installing the agent using the installation script "
on page 33 ).
-or-
Install the agent using the Linux silent installation method ("
Installing the agent using the silent
installation method " on page 34 ).
Reconfiguring the agent on Linux operating systems
To configure the management module IP address or serial path for Red Hat Linux, run
/etc/rc.d/init.d/DevMan setup
.
To configure the management module IP address or serial path for SUSE Linux Enterprise Server, run
/etc/init.d/DevMan setup
.
Installing the agent on HP-UX operating systems
The UPS Power Protection Agent can be installed using an installation script, SAM, or silent installation
option on any supported HP-UX operating system.
IMPORTANT: To ensure your system has the minimum requirements needed to run the agent,
see "UPS Power Protection Agent requirements (" HP UPS Power Protection Agent requirements "
on page 8 )."