beautypg.com

No power, Non-admin users cannot log in through telnet, On battery alarm – HP J4367A User Manual

Page 93: On boost alarm, On buck alarm, Overload alarm

background image

Troubleshooting 93

4.

Verify that the network settings are correct.

No power

Action: Verify that the UPS is connected to a working outlet and that the UPS is powered up.

Non-admin users cannot log in through telnet

Possible Cause: A user account was added, but the password was not set.
Action: An administrator must edit the user account to set a password.

On battery alarm

Action: The UPS continues to run on battery power until the battery is completely discharged (or until utility

power is restored), unless the shutdown parameters specify to turn off both the system and the UPS.

On boost alarm

Possible Cause: The input voltage is too low for the UPS. The UPS boosts the voltage up to acceptable

limits.
Action: For information on Boost mode, refer to the UPS documentation.

On buck alarm

Possible Cause: The input voltage is too high for the UPS. The UPS bucks the voltage down to acceptable

limits.
Action: For information on Buck mode, refer to the UPS documentation.

Operating system firewall prevents management
module functionality

Symptom: The management module does not connect with the agent or browser.
Action: Follow the instructions in the operating system documentation to disable the firewall or to keep the

firewall enabled with port 3573 open.

Overload alarm

Possible Cause: The device load has exceeded the UPS power rating.
Action: Verify all equipment is drawing within the rated requirements. If necessary, reduce the equipment

connected to the UPS. The UPS might need to be reset.

This manual is related to the following products: