HP vs80 User Manual

Page 47

Chapter 3

Autoloader Administration 47

Note

If the cartridge is not a valid code update cartridge, the LCD will

temporarily display error code “

,” the autoloader will reset,

the cartridge will be exported, and the LCD will display Bad

upgrade tape.

7. During the firmware update, which can take several minutes, the LCD

screen displays CODE UPDATE IN PROGRESS. When firmware update is

complete, the autoloader resets, then unloads and exports the code

update cartridge. When the LCD screen prompts you, remove the code

update cartridge and press the [Enter] button to close the door.

8. If you exported a data cartridge to make room for the code update

cartridge, be sure to import the cartridge to its original slot. See

on page 30 for instructions.

Note

After a firmware update, the firmware revision displayed on the

LCD will not be updated until the autoloader is power cycled.