Choosing a location, Choosing a location 12 – HP vs80 User Manual
Page 12
12 Installing the Autoloader
Chapter 1
Choosing a Location
Choose a location that meets the following criteria (see
on page 71 for more information on specifications):
Table 1
Location Criteria
Standalone
requirements
Select a location that is flat, sturdy, level, and close to a
host server. Do not place the autoloader on the floor or
other carpeted surfaces.
CAUTION: Do not place the autoloader on its side or
upside down or stack items that weigh more than 15 KG
on top of the autoloader.
Rack
requirements
Standard 19-inch rack with 2U of clearance.
Room
temperature
10-35º C (50-95º F)
Humidity
20-80% RH (non condensing)
Power source
■
AC power voltage: 100-127 VAC; 200-240 VAC
■
Line frequency: 50-60 Hz
NOTE:
Locate the AC outlet near the autoloader. The AC
power cord is the product’s main AC disconnect device
and must be easily accessible at all times.
Weight
10 kg (22 lbs)
Air quality
Minimal sources of particulate contamination. Avoid
areas near frequently used doors and walkways, stacks
of supplies that collect dust, printers, and smoke-filled
rooms.
CAUTION: Excessive dust and debris can damage tapes
and tape drives.
Clearance
Back
Minimum of 15 cm (6 inches)
Front
Minimum of 31 cm (12 inches)
Sides
Minimum of 5 cm (2 inches)