HP 4100GL - Manual (Page 70)

RADIUS Authentication and Accounting
Configuring RADIUS Accounting
Configuring RADIUS Accounting
RADIUS Accounting Commands Page
[no] radius-server host < ip-address > 3-19
[ acct-port < port-number >] 3-19
[key < key-string >] 3-19
[no] aaa accounting < exec | network | system > 3-21
< start-stop | stop-only> radius
[no] aaa accounting update
periodic < 1 .. 525600 > (in minutes)
3-22
[no] aaa accounting suppress null-username 3-22
show accounting 3-26
show accounting sessions 3-27
show radius accounting 3-26
N o t e This section assumes you have already:
■ Configured RADIUS authentication on the switch for one or more
access methods
■ Configured one or more RADIUS servers to support the switch
If you have not already done so, refer to “General RADIUS Setup Procedure”
on page 3-5 before continuing here.
RADIUS accounting collects data about user activity and system events and
sends it to a RADIUS server when specified events occur on the switch, such
as a logoff or a reboot. The Series 4100GL switches support three types of
accounting services:
■ Network accounting: Provides records containing the information
listed below on clients directly connected to the switch and operating
under Port-Based Access Control (802.1x):
• Acct-Session-Id • Acct-Delay-Time • Nas-Port • Service-Type
• Acct-Status-Type • Acct-Input-Packets • Acct-Output-Octets • NAS-IP-Address
• Acct-Terminate-Cause • Acct-Output-Packets • Acct-Session-Time • NAS-Identifier
• Acct-Authentic • Acct-Input-Octets • Username • Called-Station-Id
3-16