HP 4100GL - Manual (Page 37)

TACACS+ Authentication
Configuring TACACS+ on the Switch
Configuring TACACS+ on the Switch
Before You Begin
If you are new to TACACS+ authentication, HP recommends that you read the
“General Authentication Setup Procedure” on page 2-6 and configure your
TACACS+ server(s) before configuring authentication on the switch.
The switch offers three command areas for TACACS+ operation:
■ show authentication and show tacacs: Displays the switch’s TACACS+
configuration and status.
■ aaa authentication: A command for configuring the switch’s authenti-
cation methods
■ tacacs-server: A command for configuring the switch’s contact with
TACACS+ servers
CLI Commands Described in this Section
Command Page
show authentication
show tacacs
aaa authentication
console
Telnet
num-attempts <1..10 >
tacacs-server
host < ip-addr >
key
timeout < 1 ..255 >
2-10
2-10
pages 2-11 through 2-14
pages 2-15
pages 2-15
2-19
2-20
2-9