beautypg.com

Connecting to the network – HP BL685C G6 User Manual

Page 28

background image

Setup 28

HP BladeSystem c3000 Enclosure

To support network connections for specific signals, install an interconnect module in the bay

corresponding to the embedded NIC or mezzanine signals.

Server blade signal c7000 interconnect bay c3000 interconnect bay Interconnect bay labels

NIC 1 (Embedded)

1

1

NIC 2 (Embedded)

2

1

NIC 3 (Embedded)

1

1

NIC 4 (Embedded)

2

1

Mezzanine 1

3 and 4

2

Mezzanine 2

5 and 6

3 and 4

7 and 8

3 and 4

Mezzanine 3

5 and 6

3 and 4

7 and 8

3 and 4

For detailed port mapping information, see the HP BladeSystem enclosure installation poster or the

HP BladeSystem enclosure setup and installation guide on the HP website

(

http://www.hp.com/go/bladesystem/documentation

).

Connecting to the network

To connect the HP BladeSystem to a network, each enclosure must be configured with network

interconnect devices to manage signals between the server blades and the external network.
Two types of interconnect modules are available for HP BladeSystem c-Class enclosures: Pass-Thru
modules and switch modules. For more information about interconnect module options, see the HP

website (

http://www.hp.com/go/bladesystem/interconnects

).

IMPORTANT:

To connect to a network with a Pass-Thru module, always connect the Pass-Thru

module to a network device that supports Gigabit speed.

This manual is related to the following products: