beautypg.com

Remove the access panel, Install the access panel, Remove the sas hard drive – HP BL685C G6 User Manual

Page 17: Remove the solid state drive

background image

Operations 17

Remove the access panel

To remove the component:

1.

Power down the server blade (on page

15

).

2.

Remove the server blade (on page

16

).

3.

Press the access panel release button, and then slide the access panel to the rear.

4.

Remove the access panel.

WARNING:

To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

CAUTION:

To prevent damage to electrical components, properly ground the server blade

before beginning any installation procedure. Improper grounding can cause ESD.

Install the access panel

1.

Place the access panel on top of the server blade. Allow the panel to extend past the rear of the
server blade approximately 1 cm (0.25 in).

2.

Slide the access panel to the closed position.

Remove the SAS hard drive

WARNING:

To reduce the risk of personal injury from hot surfaces, allow the drives and the

internal system components to cool before touching them.

Remove the component as indicated.

Remove the solid state drive

This manual is related to the following products: