beautypg.com

Hp enhanced ethernet network board – HP Vectra VL 5/xxx Series 5 User Manual

Page 54

background image

54

3 Interface Devices and Mass-Storage Drives

HP Enhanced Ethernet Network Board

HP Enhanced Ethernet Network Board

The HP Enhanced Ethernet Network Board is supplied on some models of
the HP Vectra VL 5/xxx Series 5 PC. It is based on the AMD PCnet-PCI-II
79C970 network processor chip.

On desktop models, it is installed in a dedicated PCI accessory slot
underneath the internal, hard disk drive, rear-shelf, plugged into the PCI
Junior slot that is situated on the rear of the double-sided backplane board.

This controller is fully compliant with the 10-BaseT, 10 Mbits per second,
ISO 8802-3 (IEEE/ANSI 802.3) standard. There is a socket to support an
Option ROM of up to 32 KB. On the rear panel there is an RJ-45 unshielded
twisted-pair (UTP) connector, whose pin-out is shown in the diagram on
page 62.

Coax adapter board

Remote start

RJ-45 UTP 10 BaseT network

Hole to accept network coax BNC

Network controller