beautypg.com

Devices on the pci bus – HP Vectra VL 5/xxx Series 5 User Manual

Page 34

background image

34

2 System Board

Devices on the PCI Bus

Devices on the PCI Bus

The distribution of the interrupt lines is described more fully on page 82.

Models without any PCI boards, such as the Matrox Millennium Graphics
controller or the Ethernet Network controller, are supplied with a PCI
terminator. This should be plugged into any PCI slot, and removed if ever a
PCI accessory board is subsequently installed.

Integrated Drive Electronics (IDE)

The IDE controller is implemented as part of the PIIX3 chip (the PCI/ISA
bridge). It is driven from the PCI bus, and has PCI-Master capability. It
supports Enhanced IDE (EIDE) and Standard IDE. To use the Enhanced
IDE features the drives must be compliant with Enhanced IDE.

Up to four IDE devices are supported: two (one master and one slave)
connected to the primary channel, and two (one master and one slave) to
the secondary channel. The primary channel is fitted with an IDE cable with
two connectors. The secondary channel is fitted with an IDE cable with one
or two connectors (one for the desktop models, two for the minitower
models). If a single device (a hard disk drive or a CD-ROM drive) is attached

PCI Device

Device Name

Device

Number

Function

AD[xx]

Chip-set Interrupt Connection

DT

MT

INTA

INTB

INTC

INTD

PL/PCI bridge

TXC

0 (00h)

0

11

PCI/ISA bridge

PIIX3

15 (0Fh)

0

26

IDE controller

1

USB controller

2

Integrated graphics controller

S3 Trio 64V2

13 (0Dh)

0

24

A

PCI slot #1

J4

J6

7 (07h)

18

A

B

C

D

PCI slot #2

J3

J11

10 (0Ah)

21

D

A

B

C

PCI slot #3

J1

J5

6 (06h)

17

C

D

A

B

PCI slot #4 (minitower models)

J12

12 (0Ch)

23

B

C

D

A

PCI Proprietary slot (desktop models)

11 (0Bh)

22

C

D

A

B