Eagle Electronics IntelliMap 640C - Manual (Page 73)

67
4. The Edit Waypoint menu appears. Press EXIT repeatedly to get back
to the main page display.
Set a Waypoint by Projecting a Position
This feature creates a waypoint at a location a specific distance and
bearing from a reference position. The reference position can be a way-
point, map feature or Point of Interest.
1. Press WPT |
↑ to
M Y W AYPOINTS
|
→ to
N EW
| ENT .
2. Press
↓ to
P ROJECTED P OSITION
| ENT |
→
to C REATE
| ENT .
3. Press C HOOSE R EFERENCE
| ENT . Use
↑ and ↓ to select a waypoint, map
feature or Point of Interest. When a selection has been made press ENT.
Press
→, ↑ or ↓ to choose a subcategory, then press
ENT . Highlight
N
AME
|ENT. Spell out the name of the desired reference point in the Find
By Name box or press ENT to the find the point in the list below. After
you have selected a point, press ENT. That will launch the waypoint in-
formation window. Highlight S ET R EFERENCE
and press ENT.
4. Press
← ↓ to
D ISTANCE
| ENT . Press
↑ or ↓ to change the first character,
then press
→ to the next character and repeat until the distance is cor-
rect. Press ENT .
5. Press
↓ to
B EARING
| ENT . Press
↑ or ↓ to change the first character,
then press
→ to the next character and repeat until the bearing is cor-
rect. Press ENT .
6. Press
↑ to
P
ROJECT
| ENT . The Edit Waypoint menu appears. Press
EXIT | EXIT to get back to the main page display or press EXIT | ENT to
navigate to the new waypoint.