Eagle Electronics IntelliMap 640C - Manual (Page 118)

112
Find Waypoints
1. Press WPT |
↑ to
M
Y
W
AYPOINTS
| ENT .
2. When searching for the nearest waypoint, press ENT . If searching for
the waypoint by name, highlight N
AME
then ENT . (To search by name,
jump to step 5.)
Find By Nearest command (left). Find by Name command (center).
List of the nearest waypoints (right).
3. When you are searching for the nearest waypoint, a list of waypoints
appears with the closest location highlighted at the top of the list and
the one furthest from you at the bottom of the list.
4. To see location information on the closest waypoint, press ENT and the
Waypoint Information screen appears.
A. To navigate to the waypoint, press ENT . The Go To Waypoint
command is already highlighted. The unit will show navigation in-
formation to the waypoint.
B. To find the waypoint, press
↓
to F
IND
O
N
M
AP
| ENT . The Map Page
appears with the cursor highlighting the found waypoint.
To clear these menus and return to the previous page, press EXIT re-
peatedly.
5. If you are looking by name, there are two options. You can spell out
the name in the top selection box. Press
↑ or ↓ to change the first letter,
then press
→ to move the cursor to the next letter and repeat until the
name is correct, then press ENT | ENT . Or you can jump down to the
lower selection list by pressing ENT , then press
↓ or ↑ to select a way-
point from the list, then press ENT . The waypoint information screen
appears.