Samsung 30 Inch Slide-in Dual Fuel Smart Range Owner Manual - Manual (Page 55)

English 55
Tr
ouble
shoo
ting
Troubleshooting
If you encounter a problem with the range, check the tables starting below, and
then try the suggested actions.
Checkpoints
Gas safety
Problem Possible cause Action
You smell gas. The surface burner knob
is not in the
OFF position
and the burner is not lit.
Turn the burner knob to OFF .
There is a gas leak. Clear the room, building, or
area of all occupants.
Immediately call your gas
supplier from a neighbor’s
phone. Do not call from your
phone. It is electrical and
could cause a spark that could
ignite the gas. Follow the gas
supplier’s instructions.
If you cannot reach your
gas supplier, call the fire
department.
Surface burner
Problem Cause Action
All burners do not
light. The power cord is
not plugged into the
electrical outlet. Make sure the electrical plug
is plugged into a live, properly
grounded outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped. Replace the fuse or reset the
circuit breaker.
The gas supply is not
properly connected or
turned on. See the Installation
Instructions that came with
your range.
Surface burners do
not light. The control knob is not
set properly. Push in the control knob and
turn it to the Lite position.
The burner caps are not
in place.
The burner base is
misaligned. Clean the electrodes.
Put the burner cap on the
burner head.
Align the burner base.
Surface burner
clicks during
operation. The control knob has
been left in the Lite
position. After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks, contact
a service technician.
The burners do not
burn evenly. Surface burner
components and caps are
not assembled correctly
and level. See page 48 .
The surface burners are
dirty. Clean the surface burner
components.
(See page
47 .)
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 55 2020-03-23 6:46:20