Maintenance – Samsung 30 Inch Slide-in Dual Fuel Smart Range Owner Manual User Manual
Page 48
48 English
Maint
enanc
e
Maintenance
Brass burner head
NOTE
•
The brass parts of your burner will change
color with use. However, this will not
affect performance and you can clean the
brass parts with a brass cleaner.
•
After cleaning, confirm that the burner
port openings aren't plugged.
•
Do not wash any burner components in a
dish washer.
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by
force.
•
To avoid chipping, do not bang grates and caps against each other or against
hard surfaces, such as cast iron cookware.
•
The burner spreader can be blocked by food or dust. Clean the spreader if it
appears blocked. If you clean the spreader with water, assemble it only after it is
completely dry. If the spreader is wet, it might prevent the burners from igniting.
•
To avoid falling down the grates, make sure to remove both sides grates first.
Burner reinstall guide
Dual burner head
1.
Orient the burner head so that the
opening for the electrode lines up with
the electrode.
2.
Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies flat on the stove top.
Round burner head
1.
Orient the burner head so that the
opening for the electrode lines up with
the electrode.
2.
Install the burner head so that the
electrode passes through the opening for
the electrode. Make sure the burner head
lies flat on the stove top.
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 48
2020-03-23 6:46:16