Maintenance – Samsung 30 Inch Slide-in Dual Fuel Smart Range Owner Manual User Manual
Page 46
46 English
Maint
enanc
e
Maintenance
Door
Do not remove the inner gasket of the oven door for cleaning.
Don’t hand
clean the
oven door
gasket.
You may
hand clean
the door.
•
Use soap and water to thoroughly clean
the top, sides, and front of the oven door.
Rinse well. You may use a glass cleaner
on the outside glass of the oven door. DO
NOT immerse the door in water.
DO NOT
spray or allow water or the glass cleaner
to enter the door vents.
DO NOT use oven
cleaners, cleaning powders, or any harsh
abrasive cleaning materials on the outside
of the oven door.
•
DO NOT clean the oven door gasket.
The
oven door gasket is made of a woven
material which is essential for a good seal.
Care should be taken not to rub, damage,
or remove this gasket.
Door inner side
• Inner surface
: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket wet
or allow moisture into the door.
• Inner glass
: The inner glass is cleaned automatically during the self-cleaning
cycle.
Door outer side
• Outer surface
: Follow the cleaning instructions for the stainless steel surface in
the previous section.
• Outer glass
: Clean the outer glass using a glass cleanser or soapy water. Rinse
and dry thoroughly. Take care not to get the gasket wet or allow moisture into
the door.
*
CAUTION
Do not let moisture enter the door or
contact the door gasket (*). Moisture may
reduce the gasket’s performance.
Burner controls
Make sure all surface burner knobs are in the OFF position.
1.
Pull knobs off the control valve stems.
2.
Clean the knobs in warm, soapy water.
Then, rinse and dry them thoroughly.
3.
Clean the stainless steel surfaces using
stainless steel cleaner.
4.
Re-attach the knobs to the control valve
stems.
CAUTION
•
Do not clean the control knobs in a dish washer.
•
Do not spray cleansers directly onto the control panel. Moisture entering the
electric circuits may cause electric shock or product damage.
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 46
2020-03-23 6:46:15