Samsung 30 Inch Slide-in Dual Fuel Smart Range Owner Manual - Manual (Page 52)

52 English
Maint
enanc
e
Maintenance
Steam-cleaning
How to set the oven for steam-cleaning
For light cleaning, the steam-cleaning function saves time and energy. For heavier-
duty cleaning, use the self-cleaning function.
1. Remove all accessories from the oven.
2. Pour approximately 10 oz. (300 ml) of
water onto the bottom of the empty oven
and then close the oven door.
Use normal water only, not distilled
water.
3. Tap , and select Cleaning > Steam
Clean using the dial knob.
4. Tap START .
The oven door is locked automatically
and the oven begins to heat up.
When the operation is complete, the
display will blink and a beep will sound.
5. Press OFF .
6. Clean the oven’s interior.
There will be a significant amount of
water remaining on the bottom of the
oven after a steam-cleaning cycle.
Remove the residual water with a sponge
or soft dry cloth.
NOTE
When steam-cleaning, use exactly 10 oz. of water since this produces the best
results.
NOTE
If you start Steam Clean when the oven temperature is above 100˚F, Hot will
appear in the display. Because this function produces the best results when started
while the oven is cool, we recommend that you wait until the oven has cooled
down and Hot disappears from the display.
After a steam-cleaning cycle
•
Take care when opening the door before a steam-cleaning procedure has ended.
The water on the bottom is hot.
• Open the oven door and remove the remaining water with a sponge. Do not
leave the residual water in the oven for any length of time. Wipe the oven clean
and dry with a soft cloth. Do not forget to wipe under the oven door seal.
• Use a detergent-soaked sponge, a soft brush, or a nylon scrubber to wipe the
oven interior. Remove stubborn residue with a nylon scourer. You can remove
lime deposits with a cloth soaked in vinegar.
• If the oven remains dirty, you can repeat the procedure once the oven has
cooled.
• For heavy residue, such as grease left over from roasting, we recommend that
you rub detergent into the residue before activating the steam-cleaning function.
• After cleaning, leave the oven door ajar at a 15° angle to allow the interior
enamel surface to dry thoroughly.
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 52 2020-03-23 6:46:18