DCS Owner's Guide - Manual (Page 26)

24
IMPORTANT!
Failure to follow the steps in the order shown may cause the Flow Limiting Device to activate resulting
in extremely low gas flow and irregular operation
Grill match lighting
If the burner will not light after several attempts, then
the burner can be match lit. If you have attempted to
light the burner with the ignition, allow five minutes for
any accumulated gas to dissipate. Keep your face as far
away from the outdoor appliance as possible and hold
a paper book match over the hole located on the top
left for burner on the left, or the right hole for the right
burner (Fig. 16). Push and turn the control knob which
is centered on the burner where the lit match is located,
to “SEAR”.
If the burner does not light in four to five
seconds, turn knob off, wait five minutes and try again.
Improper lighting procedures can cause the LP tank flow control to activate resulting in reduced heat
output. If this is suspected the flow control will need to be reset.
See the Quick Start Guide for how to use the griddle and Infrared Hybrid Burner.
Refer to the Troubleshooting section of the user guide if you encounter any difficulties lighting your grill.
1 All knobs must be in the
OFF position.
2 Attach regulator hose
assembly to the tank.
3 Open the LP tank valve.
(Two full turns min).
Resetting the flow control
Grill lighting instructions
IMPORTANT!
Open the grill hood before lighting. Turn all knobs to “OFF”. Turn the main gas supply on. If you smell
gas, shut-off gas supply and call for customer care.
Pushing in on the burner knob will activate the Grill Igniter, and then turning the knob from the “OFF”
position will allow the flow of gas to the burner.
The Grill Igniter will glow orange, but there will be no clicking sound during ignition. Push in and hold the
selected burner knob for two seconds. Verify that the hot surface igniter is glowing. Turn the burner
knob to "SEAR" position. Release the knob when the burner lights. If burner does not light in four to
five sec onds, turn knob "OFF" and wait five minutes before trying again so any ac cumulated gas may
dissipate.
IMPORTANT!
Only light one burner at a time.
FIG. 16
USING THE GRILL
Lighting Instructions