Epson LABELWRITER SE450 - Manual (Page 28)

Command Reference
ASCII ESC d
Decimal 27 100
Hex 1B 64
Parameters
None
ESC E Form Feed
Description
Prints the contents of the text buffer and advances the print media. The distance the
media will advance depends on two factors: the feed distance specified by the GS L
command and the presence of a punch hole. The LabelWriter printer will advance until
a punch hole is detected or until the feed distance (specified by the GS L command)
has been reached.
When the printer is powered on, the feed distance stored in flash memory is used as the
default distance; the factory default is 7.5 inches. A new feed distance specified by the
GS L command will override the flash memory setting until the printer is either
powered down or a reset command is issued (by the ESC @ or ESC * command).
The FF and ESC E commands are the same and produce the same result.
See Also
FF
Expression
ASCII ESC E
Decimal 27 69
Hex 1B 45
Parameters
None
ESC e Set Print Temperature to Default
Used to adjust the printing strobe.
This command is also supported by the LabelWriter SE300 and the LabelWriter 400 and
450 series printers.
Expression
ASCII ESC e
Decimal 27 101
Hex 1B 65
Parameters
22