Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 - Manual (Page 87)

Memory Locations and Replacement Procedures
Matrix DFE-Gold Series Modules Hardware Installation Guide B-13
Installing the DIMM
To install a DIMM, refer to Figure B‐14 and proceed as follows:
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two
DIMM alignment notches. With the two connector arms spread outward, push the
DIMM down between the connector arms. Then release the two connector arms to
lock the DIMM into place.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Figure B-14 Installing the DIMM
1 DIMM 3 Connector arms
2 Connector fingers 4 Alignment notches (2)
В
В
А
Г
Г
Б