Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 - Manual (Page 83)

Memory Locations and Replacement Procedures
Matrix DFE-Gold Series Modules Hardware Installation Guide B-9
Removing the DRAM SIMM from 4H4203-72
To remove the existing DRAM SIMM, proceed as follows:
1. Locate the DRAM SIMM connector on the main PC board. Refer back to Figure B‐6 .
2. Push the connector arms away from the DRAM SIMM, as shown in Figure B‐11 ,
enough to release the DRAM SIMM from the connector.
Figure B-10 Installing the DRAM SIMM on 4H4282-49 or 4H4283-49
1 Connector arms 3 Connector
2 DRAM SIMM memory module 4 Alignment notches (2)
В
А
А
Б
Г
Г
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.