Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 - Manual (Page 84)

Memory Locations and Replacement Procedures
B-10 Mode Switch Bank Settings and Optional Installations
3. Pull the DRAM SIMM straight up and remove it from the connector.
Installing the DRAM SIMM on 4H4203-72
To install the DRAM SIMM, refer to Figure B‐12 and proceed as follows:
1. Push the connector arms away from the DRAM SIMM enough to insert the DRAM
SIMM into the connector fingers.
2. Insert the DRAM SIMM straight down between the connector fingers enough for the
tabs on the connector arms to align with the two DRAM SIMM alignment notches.
3. Push the DRAM SIMM down into the connector fingers. Then rotate the two
connector arms toward the DRAM SIMM to lock it into place.
Figure B-11 Removing Existing DRAM SIMM from 4H4203-72
1 Connector arms 2 Connector 3 DRAM SIMM
А
А
Б
В
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.