Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 - Manual (Page 40)

Connecting to the Network
3-10 Installation
Connecting to the Network
For connecting unshielded twisted pair (UTP) segments from the network or other
devices, refer to
• Connecting UTP Cables to 4H4282‐49 or 4H4202‐72 (page 3‐11)
• Connecting UTP Cables to 4H4283‐49 or 4H4203‐72 (page 3‐15)
For fiber‐optic connections, refer to
• Connecting Fiber‐Optic Cables to 4H4284‐49 (page 3‐18)
Figure 3-3 Installing Module into Matrix N3, N1, or N5 Chassis (Matrix N3 shown)
1 Card guides 5 Upper locking tab (shown in closed position)
2 Slot 1 (Top slot is slot 3.) 6 Lower locking tab (shown in closed position)
3 Module card 7 FTM2 backplane and power connectors
4 Metal back panel
➂
➃
➄
➅
➀
7C203-1
REDUNDANCY
PWR
100-125V~12.0A 200-240V~6.0A 50/60 Hz
7C203-1
REDUNDANCY
PWR
100-125V~12.0A 200-240V~6.0A 50/60 Hz
➁
➆
47X 1X G R O U P 4 G R O U P 1 G R O U P 2 G R O U P 3 11X 13X 23X 25X 35X 37X
RESET COM CPU
MGMT
GR OUP SELECT
GR OUP
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4
4H4282-49 F AST ENET
DFE
Note: If the DFE-Gold module is being installed in a network using Link Aggregation, there
are rules concerning the network cable and port configurations that must be followed for
Link Aggregation to operate properly. Before connecting the cables, refer to the Enterasys
Matrix DFE-Gold Series Configuration Guide for the configuration information. For details
on how to obtain manuals, refer to “
“Related Documents” on page xvi.