Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4284-49 User Manual
Page 66
Using LANVIEW
4-6 Troubleshooting
RX
(Receive)
None
No link. No activity. Port
enabled or disabled.
None.
Green
Solid. Link present, port
enabled, no traffic is being
received by the interface.
None.
Amber
Flashing. Link present, port
enabled, traffic is being
received by the interface.
Rate of flashing indicates the
data transmission rate.
None.
Red
Flashing. Fault or Error
(collision).
Contact Enterasys Networks for
technical support.
TX
(Transmit)
None
Port enabled, but no activity.
If it is known that the port should be
active and is not, contact Enterasys
Networks for technical support.
Green
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data
rate.
None.
Red
Blinking. Indicates
collisions. This indication is
only supported on 10/100
ports.
None, unless there is a high rate of
activity. In this case, check for network
configuration problems or a defective
device.
Table 4-1 LANVIEW LEDs (continued)
LED
Color
State
Recommended Action