Sound modes and surround parameters, P. 324), “sound modes and surround parameters – Denon AVR-A1H 15.4-Channel Network A/V Receiver User Manual

Page 324

1 During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.

2 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.

3 This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS:X, DTS-HD or DTS signal is played.

4 This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.

5 This can be set when the LFE signal is included in the input signal.

6 This item can be selected when Height, Ceiling or Dolby Atmos Enabled speakers are used.

7 This item can be set when any Height, Ceiling or Dolby Atmos Enabled speakers are not used, or Surround speakers are not used.

8 This item can be selected when “Surround Parameter” - “IMAX Audio Settings” in the menu is set to “Manual”. (

9 This item cannot be set when “Dynamic EQ” is set to “On”. (

10 This item cannot be set when “Speaker Configuration” - “Subwoofer” in the menu is set to “None”. (

11 This item cannot be set when Audyssey

Setup (Speaker Calibration) has not been performed.

12 This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.

13 This item cannot be set when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.

14 This item cannot be set when “MultEQ

15 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.

16 This setting is available when “Bass” - “Subwoofer Output” in the menu is set to “LFE + Main”. (

17 This item can be set when “Speaker Configuration” - “Front” is set to “Small” or “Bass” - “Subwoofer Output” is set to “LFE + Main”. (

18 This cannot be set if the input signal contains Auro-3D signals containing a Height channel.

19 This can be set if the input signal contains an Auro-3D signal.

324