Denon AVR-A1H 15.4-Channel Network A/V Receiver - Manual (Page 291)

DTS Neural:X mode cannot be selected.
0
DTS Neural:X cannot be selected when using the headphones.
Dolby Surround mode cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
IMAX DTS:X cannot be selected.
0
IMAX DTS:X and IMAX DTS cannot be selected but DTS:X and DTS can be selected, when the headphones are used.
Sound modes other than “Stereo” or “Direct” cannot be selected.
0
Only “Stereo” or “Direct” can be selected for the sound mode if Headphone:X signals are input.
Audyssey MultEQ ® XT32, Audyssey Dynamic EQ ® , Audyssey Dynamic Volume ® and Audyssey LFC™ cannot be selected.
0 These cannot be selected when you have not performed Audyssey ® Setup. ( v p. 213)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 140)
0
Audyssey Dynamic EQ ® , Audyssey Dynamic Volume ® and Audyssey LFC™ cannot be selected when sound mode is “DTS Virtual:X” or sound mode
that have “+ Virtual:X” in the sound mode name.
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. ( v p. 190)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 140)
Contents Connections Playback Settings Tips Appendix
291
Front panel Display Rear panel Remote Index