P. 236), Ozone2/3, Osettings – Denon AVR-A1H 15.4-Channel Network A/V Receiver User Manual
Page 236: Oview terminal config

o
ZONE2/3
When “Amp Assign” is “13.1ch + ZONE2/3-MONO”, the speaker
terminal used for the ZONE2/3 speakers is displayed. Depending on
the settings of Main Zone speaker configuration, the terminal is
determined automatically.
HEIGHT 3:
The HEIGHT 3 speaker terminal is used
for the ZONE2/3 speakers.
FRONT WIDE:
The FRONT WIDE speaker terminal is
used for the ZONE2/3 speakers.
SURROUND BACK:
The SURROUND BACK speaker
terminal is used for the ZONE2/3
speakers.
o
Settings
Select the signal to be output from the selected speaker terminal.
0
Only “Center” and “None” can be set for the CENTER speaker
terminal.
0
If you are using a total of seven or more Height/Ceiling/Dolby Atmos
Enabled speakers, you can only set “Top Middle”, “Surround Dolby”,
or “None” for the HEIGHT 3 speaker terminal.
0
You can use the HEIGHT 4 speaker terminal only if you are using a
total of seven or more Height/Ceiling/Dolby Atmos Enabled
speakers. You can only set “Top Surround”, “Center Height”,
“TS/CH”, or “None” for the HEIGHT 4 speaker terminal.
o
View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your “Amp Assign” setting on the menu screen.
236