Canon EOS R6 Mark II Mirrorless Camera with 24-105mm f/4-7.1 Lens - Manual (Page 417)

Time-lapse movie shooting ends if the power switch is set to < >, for
example, and the setting is changed to [ Disable ].
Even if a flash is used, it will not fire.
The following operations cancel standby for time-lapse movie recording and switch
the setting to [
Disable ].
• Selecting either [ Clean now ] in [ : Sensor cleaning ] or [ Basic settings ]
in [ Reset camera ]
• Turning the Mode dial to < >, < >, < >, < >, or < >
Image quality may be lower if you start time-lapse movie recording while a white
[
] or red [ ] icon ( ) is displayed. For best results, before
recording, wait until the white [ ] or red [ ] icon is no longer
displayed, which indicates that the camera has cooled down.
With [
Auto exposure ] set to [ Each frame ], the ISO speed, shutter speed, and
aperture value may not be recorded in the time-lapse movie Exif information in
some shooting modes.
Note
You can use Wireless Remote Control BR-E1 (sold separately) to start and stop
time-lapse movie recording.
With Wireless Remote Control BR-E1
First, pair Wireless Remote Control BR-E1 with the camera ( ).
After you take some test shots and the camera is ready to shoot (as in step
13,
), set the release timing/movie shooting switch on the BR-E1 to <●>
(immediate release) or <2> (2-sec. delay).
If the remote control's switch has been set to <
>, the time-lapse movie
recording cannot start.
Camera Status/Remote Control
Setting
<●> Immediate Release
<2> 2-sec. Delay
< > Movie Recording
Test-recording screen Test recording To recording standby
Recording standby Starts recording To test-recording screen
During time-lapse movie
recording
Ends recording Ends recording
417