Canon EOS R6 Mark II Mirrorless Camera with 24-105mm f/4-7.1 Lens - Manual (Page 346)

Images and display
Under low- or bright-light conditions, the displayed image may not reflect the
brightness of the captured image.
Although noise may be noticeable in images under low light (even at low ISO
speeds), there will be less noise in your shots, due to differences in image quality
between displayed and captured images.
The screen may flicker if the light source (lighting) changes. In this case, stop
shooting temporarily and resume under the light source you will use.
Pointing the camera at different direction may momentarily prevent correct display
of brightness. Wait until the brightness level stabilizes before shooting.
If there is a very bright light source in the image, the bright area may appear black
on the screen. However, the actual captured image will correctly show the bright
area.
Under low light, bright [ :
Screen brightness ] settings may cause noise or
irregular colors in images. However, the noise or irregular colors will not be
recorded in the captured image.
When you magnify the image, the image sharpness may look more pronounced
than in the actual setting.
Lens
If the attached lens has an Image Stabilizer and you set the Image Stabilizer switch
to <
>, the Image Stabilizer will operate at all times even if you do not press
the shutter button halfway. The Image Stabilizer consumes battery power and may
decrease the number of available shots depending on the shooting conditions.
When the Image Stabilizer is not necessary, such as when using a tripod, it is
recommended that you set the Image Stabilizer switch to <
>.
With EF lenses, focus preset during shooting is only available when using (super)
telephoto lenses equipped with this function released in and after the second half of
2011.
Note
The field of view is approx. 100% (with image quality set to JPEG ).
If the camera is idle over an extended period, the screen will turn off automatically
after the time set in [
Auto power off ] or [ Viewfinder off ] under [ : Power saving ].
The camera then turns off automatically after the time set in [ Auto power off ] ( ).
Using a commercially available HDMI cable, you can display images on a television
(
). Note that no sound will be output.
346